5.4 3v Head Gaskets
#1
06-08-2007, 08:18 AM
5.4 3v Head Gaskets
Just trying to gauge a price so I know what I need to come up with fundage wise.
5.4L 2v Iron block, with 3v Headswap. I'm told to the 3v head gaskets are what I want.
What would you reccomend ? Motor will be boosted, 16-20 PSI
5.4L 2v Iron block, with 3v Headswap. I'm told to the 3v head gaskets are what I want.
What would you reccomend ? Motor will be boosted, 16-20 PSI
#2
06-08-2007, 08:24 AM
EDITED URL.
http://www.scegaskets.com/products/ics.html
It's a copper gasket with a fine steel wire that acts like an o-ring. There's a guy on another board that's lifted his heads a handful of times with too much detonation and those gaskets have always re-sealed for him. He's running 25lbs but was at like 18-20 or so IIRC.
http://www.scegaskets.com/products/ics.html
It's a copper gasket with a fine steel wire that acts like an o-ring. There's a guy on another board that's lifted his heads a handful of times with too much detonation and those gaskets have always re-sealed for him. He's running 25lbs but was at like 18-20 or so IIRC.
#3
06-08-2007, 08:32 AM
EDITED URL.
http://www.scegaskets.com/products/ics.html
It's a copper gasket with a fine steel wire that acts like an o-ring. There's a guy on another board that's lifted his heads a handful of times with too much detonation and those gaskets have always re-sealed for him. He's running 25lbs but was at like 18-20 or so IIRC.
http://www.scegaskets.com/products/ics.html
It's a copper gasket with a fine steel wire that acts like an o-ring. There's a guy on another board that's lifted his heads a handful of times with too much detonation and those gaskets have always re-sealed for him. He's running 25lbs but was at like 18-20 or so IIRC.
#4
06-08-2007, 08:41 AM
the standard HG bore is 3.6... check with your assembler but I'm pretty sure the extra should be cool. They say they're for that specific motor and summit's been pretty good with me. I'd pick it up but call them to make sure you get the right one.
Thread
Thread Starter
Forum
Replies
Last Post
OXFORD03GT
The Parts Desk
3
01-03-2007 05:36 AM
